AUX E Series Instruções de Operação descarregar pdf (Página 19)

Page 18

Section 6 INSTALLATION

This section describes the installation procedure for the additional remote circuits available on the

Auxiliary Idle Control Module.

The Installation Instruction sheet in the kit describes the set-up of this module to the vehicle, including mounting

bracket. Locate the mating 4-pin connector under the driver's side instrument panel and connect. See Section

9.2 for connector pin-out.

NOTE:

1) DO NOT CUT THE WIRING HARNESS to extend or shorten the harness length.

Cutting the harness can damage the twisted pair communication lines and result in a non-functional system.

2) It is highly recommended that APCM IS MOUNTED IN-CAB ONLY.

Install remote switches for all exterior applications.

Section 6.1 REMOTE INPUT SWITCHES

Section 6.1.1 Remote Switch Installation

For Remote RPM Control & Remote Charge Protection, use Momentary Contact (push button) switches with

Normally Open contacts. The switches selected should be able to handle a 5VDC, 20mA nominal signal.

Quality industrial switches with gold contacts are recommended for contact durability due to the low current.

For Remote Charge Protection:

Connect switch to red VREF output wire and orange CHG input wire. The Remote Charge Protect switch

will function the same as the [CHARGE PROTECT] key on the module.

For Remote RPM Control:

Connect switch to red VREF output and gray RPM MC input. The Remote Ford switch will function the

same as the [FORD] key on the module for RPM Control activation

Red

VREF 5V

CHG

Orange

APCM

Mom/NO Switch

Red

VREF 5V

RPM MC

Gray

APCM

Mom/NO Switch

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Sem comentários

AUX E Series Instruções de Operação Página 19